Rack & Pinion versus Lead/ball Screw

You can post your problem related to Mechanical Projects here. We will try our best to help you out.
Joined:Sat Feb 18, 2017 7:21 am
Rack & Pinion versus Lead/ball Screw

Post by Robert » Thu Mar 09, 2017 9:45 am

Hi all,

Firstly I apologize if this has been posted before, but I am looking for a comparison between R&P and LS on the basis of linearly produced force. I find it difficult to get the right answers since most posts refer to these system being used in CNC machines for positioning.

I am working on a project that requires a linear force of 800N. Travel distance of 130mm, desired speed 30mm/s. When using the following equations for each device, I get the torque required for such an output.

T = 3.2N.m

Ball screw:

I used a diameter of 8mm and a lead of 8 to ensure the same travel distance per revolution. From this is it safe to say that a ball screw would be the best solution since it requires less torque from the motor? Does the mass moment of inertia of the screw equate to a considerable increase in torque required, that should be accounted for?

This is only a rough estimate to decide which of the two would work best for the application.

Your input would be appreciated.

Thank you.

Post Reply