Queries about Single Plane Balancing in Sound & Vibration Toolkit

You can post your problem related to LabView Projects here. We will try our best to help you out.
Post Reply
Helen
Posts: 12
Joined: Sat Feb 18, 2017 8:46 am

Queries about Single Plane Balancing in Sound & Vibration Toolkit

Post by Helen » Mon Mar 06, 2017 1:20 pm

I’m having questions with Single Plane Balancing project example in Sound & Vibration Toolkit as below:
- Is the Balancing example a fully completed project that can be used in practical? For example, I'm testing with rotor disk (plane) of 300mm radius and 10mm thickness.
- What is the unit for added weights (gram/kilogram…etc.)? Can I use 250g?
- Where should the weights be added with radius position? (in program only angle position is shown). I read and think that it’s can be added anywhere on radius, all weights must be at same radius, but I’m not sure.
- Is there any recommendation about the location to put vibration sensor?

I have read the project documentation carefully but there is no information regarding these. Appreciate any input from you guys.

Post Reply