Skip to datasheet
Adjustable 1 A synchronous buck converter

TPS62160 Specifications

Review TPS62160 electrical specifications, operating conditions and package details.

Package view

Key specifications

Step a higher rail down with a compact inductor and feedback divider.

Input range3–17 V Recommended supply
Output range0.9–6 V Adjustable TPS62160
Output capability1 A Subject to power and thermal limits
Switching rate2.25 MHz Typical PWM operation

Operating profile

Supply, signals and operating conditions

TPS62160 operating profile
ParameterValueConditions / notes
Example input5 VRegulated rail
Example output2.53 VNominal divider calculation
Use these values with the stated grade and test conditions.

Package details

TPS62160DSGR · WSON-8 + EP

Selected package
Selected TPS62160 physical package
PropertyDetails
ManufacturerTexas Instruments
Part numberTPS62160DSGR
PackageWSON-8 + EP
Connections9 pins
MountingSMD
Lead pitch0.5 mm
Package codeWSON-8 + EP
Thermal referenceSee operating and package limits

Operating reference

Adjustable TPS62160; distinguish fixed-output variants.

Scroll sideways to see all columns.

ParameterValueConditions / notes
Input supply3–17 VRecommended operation
Output adjustment0.9–6 VMaintain the needed input headroom
Output currentUp to 1 AInductor, thermal and input/output conditions matter
Feedback reference0.8 V nominalVOUT = 0.8 × (1 + Rtop/Rbottom)
Switching frequency2.25 MHz typicalPower-save behavior at light load
Quiescent current17 µA typicalManufacturer conditions apply

Review electrical limits and control-mode behavior in the source PDF.

Example bill of materials

5 V to approximately 2.53 V.

Scroll sideways to see all columns.

ParameterValueConditions / notes
L12.2 µHChoose sufficient saturation-current margin
CIN10 µFLow-ESR ceramic; verify effective biased capacitance
COUT22 µFAccount for voltage and temperature derating
Rtop / Rbottom390 kΩ / 180 kΩNominal output 2.533 V
PG pull-up100 kΩ to VOUTOptional status output
EN / VOSVIN / VOUT respectivelyDo not connect VOS to the switch node

Use the recommended layout and inductor/capacitor selection guidance.

Power and feedback example

Assumed load 0.5 A and efficiency 90%.

Scroll sideways to see all columns.

ParameterValueConditions / notes
Nominal output2.533 V0.8 × (1 + 390/180)
Output power1.267 W2.533 V × 0.5 A
Average input current≈ 0.281 A1.267 W / (5 V × 0.9)
Total estimated loss≈ 0.141 W1.267 W / 0.9 − 1.267 W
Ideal PWM duty≈ 50.7%VOUT/VIN; losses alter this

The assumed efficiency is illustrative; check actual curves and hardware.

Connections by function

Select a pin for its function, connection guidance and electrical notes.

Ground3 pins

Supply2 pins

Enable1 pin

Feedback and sense2 pins

Status1 pin

Read the conditions with every value

Typical values describe stated test conditions. Absolute maximum ratings are stress limits, not operating targets.

Official PDF datasheet

Component view