Skip to datasheet
Digital humidity and temperature sensor

SHT40 Basic Circuit

Build a basic SHT40 circuit with labeled pins, component values and connection guidance.

SHT40 in a circuit

Four contacts, two pullups and a local bypass capacitor.

SHT40 and 3.3V controller with two data-bus pullups and100nF bypass; four contacts and no central solder land.
Illustrative 25.00°C and 56.50%RH reading at address 0x44; heater off.

Connect it, step by step

Follow the component values and pin connections

Use a compatible supply

Power the bare sensor from 3.3 V and bypass it locally.

Connect the bus

Wire SDA and SCL with suitable pullups.

Wait and validate

After 0xFD, wait 10 ms, read six bytes and verify both CRCs.

Component view