VDDIO
Function
Digital interface supply.
How to connect
Connect to 1.2–3.6 V and bypass with 100 nF.
Electrical note
3.3 V in the example; the bare IC is not 5 V tolerant.
Explore BMP388 pins, signal names, electrical functions and connection guidance for each package.
Select a pin to explore its connection
Click a lead or use the arrow keys. Top view · pin 1 upper right
Digital interface supply.
Connect to 1.2–3.6 V and bypass with 100 nF.
3.3 V in the example; the bare IC is not 5 V tolerant.
SPI clock or I²C SCL.
Connect to the host clock; use an I²C pullup to VDDIO.
Ground connection.
Join to the common ground plane.
SPI data input or I²C SDA.
Connect to MOSI in four-wire SPI, or SDA with a pullup in I²C.
SPI output or I²C address selection.
I²C: ground selects 0x76; VDDIO selects 0x77.
Do not float in I²C; leave unconnected in three-wire SPI.
Active-low SPI chip select and protocol selection.
Hold at VDDIO from power-up for I²C.
Once driven low, I²C stays disabled until a power-on reset.
Configurable data-ready or FIFO interrupt.
Connect to a host interrupt input, or leave unconnected.
Ground connection.
Join to the common ground plane.
Ground connection.
Join to the common ground plane.
Analog sensor supply.
Connect to 1.65–3.6 V and bypass with 100 nF.