Vdd_IO
Function
Interface power supply.
How to connect
Connect to the logic rail; 3.3 V is used in the example.
Electrical note
Operating 1.71 V to Vdd + 0.1 V.
Explore LIS3DH pins, signal names, electrical functions and connection guidance for each package.
Select a pin to explore its connection
Click a lead or use the arrow keys. Top view · 5 / 3 / 5 / 3 contact banks
Interface power supply.
Connect to the logic rail; 3.3 V is used in the example.
Operating 1.71 V to Vdd + 0.1 V.
Not connected internally.
Leave open.
Not connected internally.
Leave open.
I²C clock or SPI serial clock.
For I²C, connect to host SCL with a pullup to Vdd_IO.
First ground contact.
Connect to common ground with pins 10 and 12.
I²C data, SPI data input or three-wire SPI data output.
Connect to host SDA with a Vdd_IO pullup for I²C.
SPI data output or I²C address bit.
Ground selects seven-bit address 0x18; Vdd_IO selects 0x19.
An internal pullup is present; explicitly define the chosen address.
Active-low SPI chip select and interface selection.
Tie to Vdd_IO for I²C; drive as chip select for SPI.
Second programmable inertial interrupt.
Connect to a host input when used; otherwise leave open.
Reserved contact with a required ground connection.
Connect to GND.
Do not leave this reserved pin floating.
First programmable interrupt, including data-ready routing.
Connect to a host interrupt input when needed.
Second ground contact.
Connect to common ground.
Third auxiliary ADC channel. Temperature sensing can replace this input internally.
Leave open when unused, as permitted by the manufacturer.
ADC input range is 0.8–1.6 V; it is not a full-supply-range ADC.
Sensor-core power supply.
Use 1.71–3.6 V; place 100 nF ceramic and 10 µF bulk bypass nearby.
Second auxiliary ADC channel.
Leave open when unused.
External ADC input range is 0.8–1.6 V.
First auxiliary ADC channel.
Leave open when unused.
External ADC input range is 0.8–1.6 V.