What I cannot appear to do is when connected by the USB cable, manage to use the web browser to get to the IP 172.11.11.2.
I have pinged that IP and it replies fine but when i put that in the web browser I get nothing. Says the URL could not be found.
I assume this is the say to setup the WIFI since it said so in the instructions. Also in Max I can see things under System Settings - shows IP 172.22.11.2 and 0.0.0.0 for Wireless, DNS Name etc but when I select Network settings it says no adapters found. Small Bio
When connected via USB the default IP address for myRIO is 172.22.11.2. When you said 172.11.11.2 in your post is that a typo or did you change the ip address of the myRIO?[quote=Robinson post_id=237 time=1488545417 user_id=83]I have a myRio which shows up on Max and has the software installed. I can even run programs on the FPGA and processors fine.
What I cannot appear to do is when connected by the USB cable, manage to use the web browser to get to the IP 172.11.11.2.
I have pinged that IP and it replies fine but when i put that in the web browser I get nothing. Says the URL could not be found.
I assume this is the say to setup the WIFI since it said so in the instructions. Also in Max I can see things under System Settings - shows IP 172.22.11.2 and 0.0.0.0 for Wireless, DNS Name etc but when I select Network settings it says no adapters found.[/quote]
Do you have the recommended software set installed on the myRIO (either through MAX or the Getting Started Wizard)? You'll need the
Let us know if that help or if you have follow up questions.
Recommend to read:





































