Back to Proteus Projects community Open

Proteus Projects DISCUSSION

A4954 Dual H-Bridge DC Motor Controller Board

Started by syedzainnasir A4954 Dual H-Bridge DC Motor Controller Board
1 replies 248 views 2 participants
Latest activity · 20 Feb 2017

A4954 Dual H-Bridge DC Motor Controller Board

syedzainnasir Proteus Projects Forum
#1
I am searching for a way to make an H-Bridge as a motor controller. The Dual H-Bridge board offered is a good start for now. Is the schematic avaliable so that I can complete my analysis of the design? Next, the applicaiton is for a motor voltage of 150-200 VDC. The A4954 must be removed and other low voltage components and replace with devices that function at the higher voltage. Can standard MOSFETs be mounted on this board along with a heat sink? Are there pin compatable IGBT/MOSFET driver IC that will work up to 200 VDC? Are there other solutions that you may offer? Thanks.

Community replies 1

Re: A4954 Dual H-Bridge DC Motor Controller Board

#2
[quote=Vernie post_id=67 time=1487582670 user_id=69] I am searching for a way to make an H-Bridge as a motor controller. The Dual H-Bridge board offered is a good start for now. Is the schematic avaliable so that I can complete my analysis of the design? Next, the applicaiton is for a motor voltage of 150-200 VDC. The A4954 must be removed and other low voltage components and replace with devices that function at the higher voltage. Can standard MOSFETs be mounted on this board along with a heat sink? Are there pin compatable IGBT/MOSFET driver IC that will work up to 200 VDC? Are there other solutions that you may offer? Thanks. [/quote] When it comes to DC Motor Control, I have never used H Bridge instead I always use Relay circuits to control the direction of my DC Motors. Here's some Relay links which will help you in understanding the Relay concept as well as will help yo in interfacing your DC Motor with Relays:

[url=http://theengineeringprojects.com/2012/10/what-is-relay-and-how-to-use-it.html]What is Relay and How to use it ??[/url]
[url=http://theengineeringprojects.com/2014/11/relay-simulation-in-proteus-isis.html ]Relay Simulation in Proteus[/url]
[url=http://theengineeringprojects.com/2012/11/relay-interfacing-with-microcontroller.html]Relay Interfacing with Microcontroller using ULN2003[/url]
[url=http://theengineeringprojects.com/2015/05/relay-control-using-555-timer-in-proteus-isis.html]Relay Control using 555 timer in Proteus ISIS[/url]
[url=http://theengineeringprojects.com/2013/06/dc-motor-drive-circuit-in-proteus-isis.html]DC motor Control in Proteus ISIS[/url]

I hope these tutorials will help you in interfacing of DC with Relays. Let me know if you need any help.

Thanks.
TEP COMMUNITY