Project Files of Interfacing of Flame Sensor with Arduino

Simulation is the download package that goes with our tutorial Interfacing of Flame Sensor with Arduino. On this page you can download the RAR file (35.2 KB) and see what is inside before you save it: 4 files in 2 folders, a ready Proteus simulation and an Arduino sketch. The tutorial explains the design; this page gets the files onto your computer and into use.

What this package is

Simulation is the file package of Interfacing of Flame Sensor with Arduino. Everything the article refers to is in it, named as the article names it, so you can follow along without hunting for files. It belongs to our Arduino series; the related downloads at the bottom of this page come from the same series, and the tutorial links the parts that go with it.

What is inside the RAR file

• Interfacing of Flame Sensor with Arduino.DSN – Proteus simulation, 113.1 KB
• Interfacing_of_Flame_Sensor_with_Arduino.ino – Arduino sketch, 514 B
• Interfacing of Flame Sensor with Arduino.PWI – PWI file, 2.2 KB
• Last Loaded Interfacing of Flame Sensor with Arduino.DBK – DBK file, 112.4 KB

The archive unpacks to 228.2 KB; there is no README inside, so the steps below stand in for it.

How to download

Use the download panel at the top of this page: after the counter (30 seconds for guests, 10 for members) the black button unlocks and Interfacing of Flame Sensor with Arduino.rar comes straight from our content network. If the browser opens it instead of saving, use Save as; extract the whole archive before using anything inside it.

How to install

• Step 1: Extract Interfacing of Flame Sensor with Arduino.rar with Windows (Extract All), 7-Zip or WinRAR, keeping its folders.
• Step 2: Open Interfacing_of_Flame_Sensor_with_Arduino.ino in the Arduino IDE, pick board and port and Verify (Export Compiled Binary gives the HEX).
• Step 3: Open Interfacing of Flame Sensor with Arduino.DSN in Proteus and press Play.

Simulation and results

The included Proteus project (Interfacing of Flame Sensor with Arduino.DSN) is the quickest way to see Simulation working: open it, press Play and compare with the screenshots in the tutorial. If nothing runs, make sure every library file was copied before Proteus started and that Program File points at the HEX on your disk; the FAQs tab covers the usual causes.

Read the detailed guide

This page is for the files. The full tutorial, Interfacing of Flame Sensor with Arduino, explains the circuit and the code step by step and shows the working results and the simulation; read it before you build. Questions about the download or the installation go in the comments below; more Arduino downloads are listed further down this page.

The package is free for personal, educational and research projects; credit The Engineering Projects and link to this page when you share it rather than re-uploading the file.