Project Files of Home Security System using Arduino UNO in Proteus

Home Security System using Arduino UNO in Proteus is the download package that goes with our tutorial Home Security System using Arduino UNO in Proteus. On this page you can download the ZIP file (62 KB) and see what is inside before you save it: 7 files in 2 folders, a ready Proteus simulation, an Arduino sketch and the compiled HEX firmware. The tutorial explains the design; this page gets the files onto your computer and into use.

What this package is

Home Security System using Arduino UNO in Proteus is the firmware package of Home Security System using Arduino UNO in Proteus: the compiled HEX (ArduinoCode.hex), together with the Proteus project ProteusSimulation.DSN that runs it. Build the source with the compiler the tutorial names, or load the HEX straight away to see the project work.

What is inside the ZIP file

• ProteusSimulation.DSN – Proteus simulation, 176.9 KB
• ArduinoCode.ino – Arduino sketch, 1.5 KB
• SensorDisplay.ino – Arduino sketch, 289 B
• SensorValues.ino – Arduino sketch, 590 B
• ArduinoCode.hex – Compiled HEX file, 5.4 KB
• Last Loaded ProteusSimulation.DBK – DBK file, 176.9 KB
• and 1 more, all listed in the File Structure tab

The archive unpacks to 367.1 KB; there is no README inside, so the steps below stand in for it.

How to download

Use the download panel at the top of this page: after the counter (30 seconds for guests, 10 for members) the black button unlocks and HomeSecuritySystemusingArduinoUNOinProteus.zip comes straight from our content network. If the browser opens it instead of saving, use Save as; extract the whole archive before using anything inside it.

How to install

• Step 1: Extract HomeSecuritySystemusingArduinoUNOinProteus.zip with Windows (Extract All), 7-Zip or WinRAR, keeping its folders.
• Step 2: Open ArduinoCode.ino, SensorDisplay.ino and SensorValues.ino in the Arduino IDE, pick board and port and Verify (Export Compiled Binary gives the HEX).
• Step 3: In Proteus set the controller's Program File to ArduinoCode.hex; on hardware, flash the same file.
• Step 4: Open ProteusSimulation.DSN in Proteus and press Play.

Simulation and results

The included Proteus project (ProteusSimulation.DSN) is the quickest way to see Home Security System using Arduino UNO in Proteus working: open it, press Play and compare with the screenshots in the tutorial. If nothing runs, make sure every library file was copied before Proteus started and that Program File points at the HEX on your disk; the FAQs tab covers the usual causes.

Read the detailed guide

This page is for the files. The tutorial above explains the circuit and the code step by step and shows the working results and the simulation; read it before you build. Questions about the download or the installation go in the comments below; more Arduino downloads are listed further down this page.

The package is free for personal, educational and research projects; credit The Engineering Projects and link to this page when you share it rather than re-uploading the file.