Search The Engineering Projects
113 results for Arduino Makers
Articles
See all 110Quartz Clock Movement Library for Proteus V1.0 (Arduino)
… movements and their Lavet stepping motors; this library is not made or endorsed by any clock maker, Arduino or Labcenter. Licences: the demo HEX contains the Arduino AVR core 1.8.6 (LGPL); the sketch is included and the README gives the source link. Tested in …
Split-Flap Display Library for Proteus V1.0 (Arduino + 28BYJ-48)
… data of the 28BYJ-48 stepper, maker split-flap modules and hall-effect switches; this library is not made or endorsed by any split-flap or motor maker, Arduino or Labcenter. Licences: the demo HEX contains the Arduino AVR core 1.8.6 (LGPL); the sketch is …
Air-Core Gauge Library for Proteus V1.0 (Arduino + L9110S)
… of automotive air-core gauge movements; this library is not made or endorsed by any gauge maker, Arduino or Labcenter. Licences: the demo HEX contains the Arduino AVR core 1.8.6 (LGPL); the sketch is included and the README gives the source link. The L9110S …
Turbidity Sensor Library for Proteus V1.0: Water Quality with Arduino
… With the switch on D, OUT also works on a digital pin. The Arduino Code The demo sketch needs no library. New to Arduino? Start with Arduino Tutorial for Beginners and Introduction to Arduino UNO . The pin, the reference voltage and the number of readings: …
Parts
Split-Flap Display
… with the two halves of each character hang on a spool; as a motor turns it, the next flap falls and shows the next character. Maker modules use a 28BYJ-48 stepper and a hall sensor that finds home once a turn.
SIM800C
SIMCom SIM800C quad-band GSM / GPRS module (850, 900, 1800 and 1900 MHz). An Arduino controls it over UART with AT commands; makers often buy it on the small blue HW-537 board, which is switched on with its PWX power key.
TTP223
Tontek TTP223 single-key capacitive touch pad detector. Makers use it on a small red module with a round touch pad, one LED and two solder jumpers (A: active high / low, B: toggle); with both open, its I/O pin is HIGH while the pad is touched. It works from …