Date: "28 - April - 2015"

4 articles found.

LED Blinking using 555 Timer

Back and forth LED pattern using a 555 and CD4017, CD4017 counter, sequential LED pattern, Proteus simulation

Hello friends! Today we will make six LEDs light in a back-and-forth sequence using a 555 timer and a CD4017 decade counter. This extends our multiple LED flasher : instead of switching two whole banks, we will select a different position after each clock pulse. The timer controls how quickly the pattern advances. The counter decides which of ten states is active, and an output-mapping network converts those ten states into a six-position outward-and-return pattern. Separating those jobs makes the circuit easier to understand and troubleshoot. The original screenshots and download remain below. We will correct the description of the 4017 and replace the old output-combining method with diode isolation. Resistors between opposing outputs do not turn those outputs into a proper logic OR func ...

LM317 Voltage Regulator in Proteus

LM317 variable voltage simulation overview, LM317 regulator, adjustable DC supply, Proteus simulation

Hello friends! Today we will build an adjustable DC supply using an LM317 voltage regulator in Proteus. We will calculate the output-setting resistors, check the available voltage range, and see why load current and temperature matter as much as the potentiometer setting. Our earlier 5 V supply using a 7805 provides a fixed output. The LM317 uses an external resistor network to set its output, making it useful when a project needs a different low-voltage supply. It does not, however, provide every voltage from zero to the input voltage. The original motor demonstration, images, video and download remain in this tutorial. We will explain the historical readings while correcting its missing LED current limiter, capacitor choices and assumptions about the maximum output. Start with a resistiv ...

Angle Control of Servo Motor using 555 Timer in Proteus ISIS

Historical servo angle control simulation using a 555 timer, 555 timer servo controller, pulse width control, Proteus simulation

Hello friends! Today we will control a hobby servo from a 555 timer in Proteus ISIS. We will generate a repeating position-command pulse, measure its width, and see how changing that width changes the simulated shaft position. This project is a useful way to connect timer theory with motion control. The servo has its own internal motor driver and feedback system; our 555 supplies a command signal, not the motor's operating current. The command pulse must have suitable voltage levels, timing and repetition. The original diagrams and download are preserved below. We will correct two important points from the older explanation: a servo does not universally rotate from −180 to +180 degrees, and the 555's threshold is a fraction of its supply rather than a fixed 5 V value. Figure: Historical se ...

LED Dimming Project Using 555 Timer in Proteus ISIS

Original LED dimming circuit in Proteus, 555 timer dimming, BC547 LED circuit, Proteus simulation

Hello friends! Today we will study LED dimming using a 555 timer in Proteus ISIS. In our earlier single and double LED flasher and multiple LED flasher , the visible effect was a repeated change between on and off. Here we want to understand how a circuit changes apparent brightness. We will first examine the original fading demonstration, then build a controlled pulse-width-modulation example. PWM lets us change the fraction of time an LED conducts while keeping its on-state current limited. The important measurements are pulse width, repetition period and LED current. The original screenshots and download are retained. Their off, dim and bright images show the intended visual effect, but a still image cannot establish the electrical waveform. We will use the oscilloscope to distinguish a ...