Hello friends, I hope you all are doing great. Today, I am going to share the new Arduino Pro Mini Library for Proteus V4.0 . The Arduino Pro Mini is the tiny red board from SparkFun: an ATmega328P, a resonator, a voltage regulator and a reset button on a board of 0.7 x 1.3 inches, with no USB connector at all. You program it through a six-pin FTDI header on one end. With this Arduino Pro Mini Library for Proteus , you place the board on your sheet, load the HEX file of your sketch and press Run: the PWR LED lights, the 13 LED follows pin 13, the RESET button works with the bootloader, and a serial monitor built into the board shows everything your sketch prints. Version 4.0 is the newest of our Arduino libraries for Proteus; the first one came out in 2015. The Pro Mini is one of six board ...
Hello friends, I hope you all are doing great. Today, I am going to share the new Arduino Mega 2560 Library for Proteus V4.0 . The Arduino Mega 2560 is the big brother of the Arduino UNO: the same 5 V, 16 MHz AVR family, but with the ATmega2560, 54 digital pins, 16 analog inputs and four hardware serial ports. With this Arduino Mega 2560 Library for Proteus , you place a Mega 2560 that looks like the real board, load your sketch's HEX file and press Run: the ON LED lights up, L blinks on pin 13, TX and RX flash with the serial traffic, and a serial monitor opens on its own. Version 4.0 is the next version of our Arduino libraries for Proteus; the earlier versions go back to 2015, and V3.0 came in 2023. The chip inside is still Proteus's own AVR model, so your sketches run as before. What i ...
