Hello friends, I hope you are doing well. In today's tutorial, I am going to share our CC1101 Proteus Library . With this library, we can place two CC1101 RF modules in one Proteus design, connect each module to an Arduino Uno and send messages from one board to the other at 433.92 MHz. The receiver prints every message with its signal strength, and a row of distance buttons lets us test how far the link can reach. We will start with the basics of the module, install the library files and wire the circuit. After that, we will run the supplied two-Arduino simulation, change the distance between the radios and understand both Arduino sketches. We will also calculate the signal strength values shown on the Virtual Terminal. The download includes the wired project, two compiled HEX files, both ...
Hello friends, I hope you are doing well. In today's tutorial, I am going to share our EM-18 RFID Proteus Library . With this library, we can connect an EM-18 RFID reader to an Arduino Uno and tap a virtual card on the reader with a single click. The Arduino receives the tag number through a serial line, checks it and prints whether access is granted or denied. We will start with the basics of the reader, install the library files and wire the circuit. After that, we will run the supplied simulation, understand the Arduino code and calculate the checksum that protects every tag number. The download includes the wired project, compiled HEX and editable sketch, so you can run the example before compiling anything yourself. This tutorial uses our V1.0 package , the TEP Arduino UNO V3 and a 16 ...
