Project Files of Arduino Mega 2560 Library for Proteus V2.0

This is the download page of Arduino Mega 2560 Library for Proteus V2.0, the file package of the tutorial Arduino Mega 2560 Library for Proteus V2.0, published on The Engineering Projects in March 2021. Here you get the ZIP file (45.9 KB) with the Proteus library files (LIB and IDX), a ready Proteus simulation, an Arduino sketch and the compiled HEX firmware, the list of files it contains, the README when there is one, and the installation steps in order.

What this library is

Arduino Mega 2560 Library for Proteus V2.0 adds Arduino Mega 2560 to Proteus as a schematic component: once installed, the part appears in the Pick Devices list under its own name, with its real pin layout, and can be placed and wired like any built-in device. It is a symbol-and-footprint library: it draws and routes the part; to see it work in simulation, pair it with the HEX file or the controller model as the tutorial shows. This is version 2.0, the release the tutorial was written for; older or newer releases, when they exist, are listed in the Development tab.

What is inside the ZIP file

• ArduinoMega25602TEP.LIB – Proteus library, 25.9 KB
• ArduinoMega25602TEP.IDX – Library index, 162 B
• Arduino Mega 2560 Library for Proteus V2.0.DSN – Proteus simulation, 108.9 KB
• ArduinoCode.ino – Arduino sketch, 447 B
• ArduinoCode.ino.hex – Compiled HEX file, 6.5 KB
• Arduino Mega 2560 Library for Proteus V2.0.PWI – PWI file, 1.3 KB
• and 1 more, all listed in the File Structure tab

The archive unpacks to 259.2 KB; there is no README inside, so the steps below stand in for it.

How to download

Use the download panel at the top of this page: after the counter (30 seconds for guests, 10 for members) the black button unlocks and ArduinoMega2560LibraryforProteusV2.0.zip comes straight from our content network. If the browser opens it instead of saving, use Save as; extract the whole archive before using anything inside it.

How to install

• Step 1: Extract ArduinoMega2560LibraryforProteusV2.0.zip with Windows (Extract All), 7-Zip or WinRAR, keeping its folders.
• Step 2: Close Proteus and copy ArduinoMega25602TEP.LIB and ArduinoMega25602TEP.IDX into its LIBRARY folder (Proteus 8: C:\Program Files (x86)\Labcenter Electronics\Proteus 8 Professional\LIBRARY).
• Step 3: Start Proteus, press P and search for "ArduinoMega25602TEP"; place and wire it as in the tutorial.
• Step 4: Open ArduinoCode.ino in the Arduino IDE, pick board and port and Verify (Export Compiled Binary gives the HEX).
• Step 5: In Proteus set the controller's Program File to ArduinoCode.ino.hex; on hardware, flash the same file.
• Step 6: Open Arduino Mega 2560 Library for Proteus V2.0.DSN in Proteus and press Play.

Read the detailed guide

This page is for the files. The tutorial above explains the circuit and the code step by step and shows the working results and the simulation; read it before you build. Questions about the download or the installation go in the comments below; more Proteus downloads are listed further down this page.